Telecom Engineer - Oil & Gas

Role & responsibilities

1. Telecom System Block Diagrams
• Overall architecture
  
• Equipment and network topology
  
• Interfaces between systems
  
• Fiber/copper connectivity
  
• Redundancy and network architecture
  
2. Material Requisitions (MR)
• PAGA MR
  
• CCTV MR
  
• Telecom equipment MR
  
• Preparation of equipment/material datasheets
  
• Technical requisitions and specifications
  
• Technical bid evaluation (TBE)
  
• Vendor document review
  
3. Telecom Specifications
• PAGA specification
  
• CCTV specification
  
• General telecom specification
  
• Equipment specifications/datasheets
  
• Installation and testing requirements
  
4. Telecom Design Documents
• System block diagrams
  
• Equipment layouts
  
• Cable schedules
  
• Cable routing
  
• Telecom room layouts
  
• JB/termination details
  
• I/O/interface schedules
  
• Equipment schedules
  
• Data sheets
  
• Cause & Effect / alarm philosophy where applicable
  
• FEED, Basic Engineering and Detailed Engineering phases
  

• FAT, SAT, installation, commissioning and handover

Preferred candidate profile

The engineer should have strong experience with:

• PAGA (Public Address & General Alarm) system architecture, zoning, speaker/horn selection, amplifiers, controllers, interfaces, and cause & effect.
  
• CCTV IP/analog CCTV architecture, cameras, VMS/NVR, storage, network switches, monitors, UPS, fiber/copper connectivity, and hazardous-area requirements.
  
• Telecommunication systems — telephone, intercom, radio, LAN/WAN, fiber optic, access control, and other project-specific systems.
  
• Industrial communication — interfaces with DCS, ESD, F&G, SCADA, and other control systems where applicable.